The new MiraCurl® SteamTech, with a steam option that creates 20% higher curl definition, 50% better curl formation and 24-hour hold, features an additional heater for even faster and more powerful surround heat. Creates curls that outlast and outshine anything you've ever experienced.

MIRACURL® STEAMTECH TIPS AND TRICKS


For MiraCurl SteamTech, Turn the steam function on if desired. Refer to “Steam function” and “Filling the water reservoir” sections below.



Steam function – Fill the reservoir as described. Turn the machine on and allow it to heat up before turning on the steam function. Once the red light stops blinking, turn the steam on/off switch to ON. If not using steam, make sure switch is set to OFF and empty the water reservoir.
Filling the water reservoir
1. To fill the reservoir, remove it by slightly lifting the edge and pulling it out of the unit.

2. Open the black rubber cap and fill reservoir with distilled water.

3. Replace the cap, making sure it is tightly sealed and lock the reservoir back into the unit – you will hear a “click.”

4. Make sure the unit is OFF when removing, filling or putting the reservoir back into the unit.

While emitting steam always use according to instructions, and keep unit 1" away from scalp.
Once you turn the steam option on, simply insert hair strand and close the unit. The steam will flow as curl is forming.

NOTE: Opening and closing unit rapidly with steam function ON may cause excess water to flow, bubbling and noise.